Mitsubishi Electric CR800-D Series - Consumption Degree Calculation Function; Maintenance Parts and Overhaul Parts Classification

Consumption degree calculation function 52
6. Consumption degree calculation function
This function calculates the consumption degree [%] of robot components based on the actual operating
status (motor speed, load status, and others), and calculates the period up to maintenance/inspection or
overhaul.
The screen indicates the consumption degree of each joint axis of maintenance parts and overhaul parts
calculated by the consumption degree calculation function.
The current status of maintenance parts (grease, timing belt) and overhaul parts (reduction gear, bearing,
ball screw/ball spline) is displayed, separately in two screens. Also, the current status is displayed as the
predictive maintenance message.
Maintenance parts and overhaul parts
Maintenance parts
Grease, timing belt
Overhaul parts
Reduction gear, bearing, ball screw/ball spline
1) Start predictive maintenance.
2) Click [Total Score] - [Consumption Degree] to expend the menu.
3) When you select "Maintenance Parts" or "Overhaul Parts", the consumption degree of each part
of the target axis and each joint axis is displayed.
Maintenance parts
Overhaul parts
Consumption degree
calculation
(1) Consumption degree
(1) Consumption degree
(2) Predictive maintenance message
(2) Predictive maintenance message
3) Output CSV
gree
3) Output CSV
gree