Mitsubishi Electric CR800-D Series - Set Predictive Maintenance Function Enable Parameter

Startup and initial settings 45
Set the function code of the MELFA Smart Plus card.
2
1) Start RT ToolBox3 that performs the maintenance simulation. At that time, click the right button of
the mouse on the desktop icon of RT ToolBox3 and select "Implement as administrator" from the
displayed menu.
2) Select [Option] from the [Workspace] tab of RT ToolBox3.
3) From the left tree on the Option screen, select MELFA Smart Plus.
4) Enter the MELFA Smart Plus card function code obtained in Step 1 to the "Function code" field.
5) Press the Set button.
6) Press the OK button and restart RT ToolBox3.
Next, enter the function code obtained in Step 1 to the RT ToolBox3 that performs the maintenance
simulation.
2) Option
4) Enter the function code.
3) MELFA Smart Plus
Option screen
5) Setting
6) OK
Set the predictive maintenance function enable parameter.
3
Set the parameter to enable predictive maintenance.
1) Open the workspace that performs the maintenance simulation. Open the project.
2) Open the parameter list of the project that performs the maintenance simulation.
3) Set the "PMENA" predictive maintenance function parameter to [1: Enable].
PMENA
Parameter List screen
Set the "PMENA"
parameter for
each project.