Mitsubishi Electric CR800-D Series - Program Operation; Simulation Results Displayed

Maintenance simulation 73
The simulation results are displayed.
6
The maintenance simulation result displayed is when the operation from clicking the "Start" button in
Step 4 to clicking the "End" button in Step 5 is repeated.
1) When program operation ends, the maintenance simulation results are displayed.
The displayed results are estimated results based on the value of "Operation Time of a Day" and
"Working Days in a Month".
2) After changing the value of "Operation Time of a Day" and "Working Days in a Month", click the
"Update Graph" button. The simulation results recalculated by the changed conditions are displayed.
3) When you click the “Save” button ,output maintenance simulation results in the CSV format.
*Storage destination and file name of the CSV file
Storage destination: [Folder for workspace]¥[Project name]¥Maintenance¥PMLog
File name: [SimulationDataYYYYMMD-HHMMSS].csv
4) Click the "Retry" button to return to the initial screen of maintenance simulation.
5) The graph and the number of years are not displayed for joint axes that do not use the target parts.
The number of years up to the replacement time of grease and the timing belt are displayed. Also, for overhaul
parts, of the reduction gear, bearing, ball screw/ball spline, the number of years of the part having the least
years are displayed for each joint axis.
Maintenance Simulation result display
4) Axes that do not
use target parts
Number of years up to
replacement for each
joint axis name
4) Back
2) Operation time of a day
Working days in a month
2) Update graph
3) Save
Number of years up to replacement time
for each part (number of years of joint
axis having the least number of years)
Number of years up to the
recommended overhaul time for
each joint axis name