What to do if there is a CC-Link data link error on Mitsubishi Electric Controller?
If you encounter a CC-Link data link error, specifically a local station connection error, it may be due to a line error or invalid parameter settings on the master station. Review the line and parameters.
What to do if I see ‘Origin unsetting (base coop)’ error on Mitsubishi Electric Robotics?
If you encounter an 'Origin unsetting (base coop)' error with your Mitsubishi Electric Robotics, it means that axis tracking cannot be executed because of origin unsetting. To resolve this, set the origin and then turn the power OFF and then ON again.
What to do if I see ‘Origin unsetting (axis tracking)’ error on Mitsubishi Electric Robotics?
If you encounter an 'Origin unsetting (axis tracking)' error with your Mitsubishi Electric Robotics, it means that axis tracking cannot be executed because of origin unsetting. To resolve this, set the origin and then turn the power OFF and then ON again.
How to resolve 'CC-Link card is illegal' error on Mitsubishi Electric Controller?
If your Mitsubishi Electric Controller displays a 'CC-Link card is illegal' error, you should exchange the CC-Link card.
Why can't I set a CC-Link master station on my Mitsubishi Electric Controller?
If you cannot set a CC-Link master station on your Mitsubishi Electric Controller, it is because a master station is already set by the rotary switch. Set the rotary switch to a setting other than 0.
What to do if two CC-Link interface cards are mounted on Mitsubishi Electric Controller?
If two CC-Link interface cards are mounted on your Mitsubishi Electric Controller, mount one card in slot 2. It is not allowed to install two cards, so install only one card.
What happens if a CC-Link register number is outside the range on Mitsubishi Electric Controller?
If a CC-Link register number is outside the allowable range on your Mitsubishi Electric Controller, it means that the entered register number is incorrect. Enter the correct value to resolve this.
How to fix CC-Link initialization error on Mitsubishi Electric Controller?
A CC-Link initialization error on your Mitsubishi Electric Controller occurs when the master station's parameters do not match. Correct the parameters, and then restart the system.
Why does my Mitsubishi Electric Controller show a CC-Link cable error?
A CC-Link cable error on your Mitsubishi Electric Controller indicates that either the cable is not properly connected or the parameters do not match. To resolve this, reset the power and start the system again.
General| Brand | Mitsubishi Electric |
|---|---|
| Model | MELFA CR800-D Series |
| Category | Robotics |
| Language | English |
To Next Page
