Mitsubishi Electric MELSEC iQ-R - Page 182

180
1 FUNCTIONS
1.12 Configuration Function
Event notification send setting
Send an Event notification from a BACnet module to another BACnet device.
An Event notification is sent when the vale of an EventState property (event status) is changed.
Set the conditions to make an event generate with the following objects.
Page 180 AnalogInput object/AnalogOutput object/AnalogValue object
Page 183 BinaryInput object/BinaryOutput object/BinaryValue object
Page 183 MultiStateInput object/MultiStateOutput object/MultiStateValue object
Page 184 Accumulator object
For the setting example to send Event notifications, refer to the following section.
Page 185 Example of an Event notification send setting
■ AnalogInput object/AnalogOutput object/AnalogValue object
Property Description Remarks
HighLimit Specify an upper limit value for a PresentValue property.
When a PresentValue property value becomes greater than the specified value, an
EventState property value is changed to HighLimit.

LowLimit Specify a lower limit value for a PresentValue property.
When a PresentValue property value becomes less than the specified value, an
EventState property value is changed to LowLimit.

Deadband Specify the dead band of the HighLimit and the LowLimit. 
TimeDelay Specify the time interval from when a PresentValue property value is changed to when
an EventState property value is changed. (Unit: seconds)
To send an Event notification
immediately after the value is changed,
specify '0'.
LimitEnable LowLimitEnable Select this to send an Event notification when a PresentValue
property value becomes less than the value specified to the
LowLimit property.
To send an Event notification, select
the event to be notified.
HighLimitEnable Select this to send an Event notification when a PresentValue
property value becomes greater than the value specified to the
HighLimit property.
EventEnable ToOffnormal Select this to send an Event notification when an EventState
property is changed to Offnormal.
To send an Event notification, select
the event to be notified.
ToFault Select this to send an Event notification when an EventState
property value is changed to Fault.
ToNormal Select this to send an Event notification when an EventState
property is changed to Normal.
NotificationClass Specify the NotificationClass object which manages the send target of Event
notifications.
For the NotificationClass object, refer
to the following section.
Page 102 NotificationClass (NC)
object
IntrinsicEventDisable Set whether to detect the satisfaction of a condition. To send an Event notification, specify
False.