10 BLOCK LINK EXAMPLES
10.5 PWM Output
187
10
10.5 PWM Output
The multi function counter block outputs a PWM wave with a specified duty ratio.
The following describes a link and parameter example of a PWM output. With the example setting, when a rise of the input
signal 0 is detected, output of the following PWM wave starts, and when a rise of the input signal 1 is detected, the output
stops. Note that this link example is for when a 32-bit unsigned multi function counter block is used.
Link and parameter
The following shows a link example of the hardware logic outline window and a link example and parameter setting example
of the multi function counter block detail window.
■Hardware logic outline window
7ms3ms 7ms
ON
OFF
3ms
Cycle time ON time
Output signal
PWM output
start signal
PWM output
stop signal
PWM wave
output
To Next Page
Loading...
