64
8 FUNCTIONS OF THE CONFIGURATION TOOL
8.2 Starting and Exiting the Configuration Tool
8.2 Starting and Exiting the Configuration Tool
This section describes how to start and exit the configuration tool.
Start
Before starting the configuration tool, add the module with GX Works2. The following describes the operation method.
1. Add the flexible high-speed I/O control module on GX Works2.
[Project window] of GX Works2 [Intelligent Function Module] Right-click [New Module]
2. Write the set parameters into the CPU module.
3. Start the configuration tool.
[Start] [All Programs] [MELSOFT] [FlexIo Configurator] [FlexIo_Configurator]
4. Input the start I/O number of the flexible high-speed I/O control module and click [OK].
To Next Page
Loading...
