2 PART NAMES
21
2
2 PART NAMES
This chapter lists the part names of the flexible high-speed I/O control module.
*1 For differential output terminals, the LED indicates the ON/OFF status of each differential output+ signal.
No. Name Description
(1) Module joint lever A lever for connecting two modules
(2) RUN LED This LED indicates the operating status.
On: Normal operation
Flashing: During simulation
Off: When 5V power off or a watchdog timer error has occurred
(3) ERR. LED This LED indicates the error status.
On: An error has occurred.
Off: Normal operation
(4) Indicator LED This LED indicates the I/O status of external I/O terminals.
LED0
(Upper section)
This LED indicates the input status of each external input terminal.
• On: A voltage has been applied.
• Off: No voltage has been applied.
0 to B indicate external input terminals (IN 0 to IN B).
LED1
(Lower section)
This LED indicates the output status of each external output terminal.
*1
• On: A signal output is on.
• Off: A signal output is off.
0 to D indicate the following external output terminals.
• 0 to 7: OUT 0 to OUT 7
• 8 to D: OUT 0_DIF to OUT 5_DIF
(5) Connector for external devices (40 pins) A connector used to connect encoders and control devices. For the terminal layout, refer to the
following.
Page 43 Interface with external devices
(6) DIN rail hook A hook used to mount the module to a DIN rail
(7) Serial number marking Displays the serial number printed on the rating plate.
(1)
(2)
(4)
(1)
(7) (1)
(5)
(6)
(3)
To Next Page
Loading...
