13 PROGRAMMING
13.2 When the Module Is Used with the Standard System Configuration
211
13
13.2 When the Module Is Used with the Standard
System Configuration
This section shows a program example with the following system configuration and conditions.
System configuration
The following figure shows a system configuration example.
Programming conditions
The program counts pulses (2-phase multiple of 4) input to the flexible high-speed I/O control module with the multi function
counter block.
Adding the module
Add the flexible high-speed I/O control module on GX Works2.
For details on adding the module, refer to the following.
Page 204 Adding the Module
Use the default values for the switch setting and auto refresh setting in these program examples.
Starting the configuration tool
Start the configuration tool with the following procedure.
Page 64 Starting and Exiting the Configuration Tool
LD40PD01
Power supply module (L61P)
END cover (L6EC)
CPU module (L26CPU-BT)
X/Y00
to
X/Y0F
X/Y30
to
X/Y4F
X/Y10
to
X/Y2F
To Next Page
Loading...
