289
CHAPTER 16 TROUBLESHOOTING
16
16.7 Error Code List
16.7.3 Error codes stored in the buffer memory
C105
H
System error (The OS detected an error.)
• Follow the procedure below.
(1) Check if the Ethernet module, the power supply
module, and the CPU module are properly connected.
(2) Check if the operating environment of the Ethernet
module conforms to the general specifications of the
CPU module.
(3) Check if the power capacity is sufficient.
(4) Check if the hardware is normal according to the
manual for each module.
If the actions above do not solve the problem, please consult
your local Mitsubishi representative.
C106
H
System error (The OS detected an error.)
• Follow the procedure below.
(1) Check if the Ethernet module, the power supply
module, and the CPU module are properly connected.
(2) Check if the operating environment of the Ethernet
module conforms to the general specifications of the
CPU module.
(3) Check if the power capacity is sufficient.
(4) Check if the hardware is normal according to the
manual for each module.
If the actions above do not solve the problem, please consult
your local Mitsubishi representative.
C110
H
System error (The OS detected an error.)
• Follow the procedure below.
(1) Check if the Ethernet module, the power supply
module, and the CPU module are properly connected.
(2) Check if the operating environment of the Ethernet
module conforms to the general specifications of the
CPU module.
(3) Check if the power capacity is sufficient.
(4) Check if the hardware is normal according to the
manual for each module.
If the actions above do not solve the problem, please consult
your local Mitsubishi representative.
C111
H
A response could not be received from the DNS client.
• Check the cables and hubs.
• Check if communications with the DNS server can be
performed using the PING command.
C112
H
A response from the POP3 layer could not be received.
• Check if the POP3 server name has been registered in the
DNS.
• Delete the POP3 server name and change the setting to
the IP address setting. Then check the operation.
• Check if communications with the POP3 server can be
performed using the PING command.
C113
H
An e-mail without an attachment was received. (This error
occurs when an attachment is not read normally.)
• Specify the attachment on the sending side.
• Check the program on the sending side.
• If data sending using the MSEND instruction previously
failed with the sending source of the mail server, check the
destination of the MSEND instruction.
• Check if the e-mail specifications, such as the
encoding/decoding style and file format, on the sending
side are the same as those for the Ethernet module.
• Receive an e-mail with an unknown destination and
unknown destination server from the SMTP server.
Error code Error description Action
To Next Page
Loading...
