Mitsubishi Electric WS0-CPU0 - Page 144

Chapter 9
141
Logic programming – Function blocks
 Choose the number of inputs which you would like to attach to the function block.
 Then click the Parameter tab and choose the zone by checking the boxes.
If only AND logic is needed, leave the Zone 2 AND function block inputs unchecked.
If additional OR logic is required in the application, the inputs can be combined
using the Zone 1 and Zone 2 AND function blocks and subsequently connecting to
the internal OR function block.
 Finally select the output for Fast shut off.
Figure 116:
Parameter settings dialog
for the Fast shut off function
block
Note
Figure 117:
Output selection for Fast
shut off