Mitsubishi Electric WS0-CPU0 - Editing the communication settings

Chapter 6
70
Connecting to the MELSEC-WS safety controller
6.2 Editing the communication settings
Using the COM settings command, you can create, edit and delete connection
profiles.
To edit the connection profiles, the Setting and Monitoring Tool must be in offline mode.
 If you are in online mode, click on the Disconnect button to change into offline mode.
 Click on COM settings. The dialog for editing the connection profiles is opened:
All existing connection profiles are displayed here. The currently activated profile is
marked light green and with bold typeface; the profile selected for editing is marked
blue.
At the bottom of the dialog an overview of the current settings is displayed.
The symbols for editing the profiles have the following meaning:
Symbol Meaning
Save profile with the current project
Activate profile
Edit profile
Remove profile
Check connection
Figure 41:
Connection settings dialog
Table 10:
Symbols for editing the
connection profiles in the
Connection settings dialog