Chapter 6
78
Connecting to the MELSEC-WS safety controller
The password may consist of 8 characters maximally.
6.5 Identify project
The Identify project command is equivalent to the Connect to physical device
command that can be executed upon program start of the Setting and Monitoring
Tool.
In the Device menu, choose the Identify project command. The current project
will be closed.
The Setting and Monitoring Tool will search for connected MELSEC-WS modules
and load the hardware configuration into the Hardware configuration dialog.
Once all modules have been identified, the Setting and Monitoring Tool will ask
whether the configuration shall be uploaded.
Click Yes if you want to upload the configuration.
Note
Figure 47:
Change password dialog
To Next Page
Loading...
