Mitsubishi Electric WS0-CPU0 - Routing 1:N

Chapter 9
153
Logic programming – Function blocks
 Then click the Message assignment tab. Assign the desired message to each
used input and choose the input condition that must be fulfilled for the related
message to be sent (rising edge, falling edge or rising and falling edge).
The message assignment can not be exported or imported.
Message priority
If more than one conditions are fulfilled at the same time, the following priorities apply:
 On a single Log generator function block, the input with the lower number is
prioritized, i.e. the message triggered by this input will be logged first.
 If several Log generator function blocks are used, the function block with the lower
function block index is prioritized, i.e. the messages generated by this function block
will be logged first.
9.7.17 Routing 1:N
Function block diagram
General description
The Routing 1:N function block passes an input signal from a preceding function block
to up to eight output signals. This function block makes it possible to connect an
output of a function block or an input element with several output elements (e.g.
outputs of a WS0-XTIO module, CPU marker). It is not needed, however, for the
connection to several function block inputs, because this can be done directly.
Parameters of the function block
Parameter Possible values
Number of outputs 1 to 8
Note
Figure 129:
Message assignment for the
Log generator function block
Figure 130:
Function block diagram for
the Routing 1:N function
block
Table 61:
Parameters of the Routing
1:N function block