Chapter 9
152
Logic programming – Function blocks
To configure the Log generator function block, proceed as follows:
Connect input elements to the function block. Double click on the function block to
open the configuration dialog and click then on the I/O settings tab.
Choose the number of inputs that you wish to attach to the function block.
Then click the Messages tab and enter the messages that shall be output in the
diagnostics.
– The messages entered are valid globally for all Log generator function blocks
used in a project.
– In a single project, you can enter up to 64 different messages with a length of up
to 32767 characters each.
– Using the Import from CSV and Export to CSV buttons at the top left of the
window, you can save the messages to a text file in CSV (comma separated
values) format or import messages from a CSV file.
Figure 127:
I/O settings for the Log
generator function block
Figure 128:
Messages of the Log
generator function block
Note
To Next Page
Loading...
