13
9.10.3 Information on wiring ............................................................................ 216
9.10.4 State transition from Stop to Run .......................................................... 217
9.10.5 Error states and information on resetting ............................................. 217
9.10.6 Parallel muting ...................................................................................... 218
9.10.7 Sequential muting ................................................................................. 220
9.10.8 Cross muting – direction of movement only forwards or backwards .... 222
9.10.9 Cross muting – material transport in both directions ............................ 224
9.11 Function blocks for press contact monitoring .............................................. 226
9.11.1 Overview and general description ........................................................ 226
9.11.2 Eccentric press contact ......................................................................... 226
9.11.3 Universal press contact ........................................................................ 232
9.12 Function blocks for press cycle control ....................................................... 240
9.12.1 Press setup ........................................................................................... 240
9.12.2 Press single stroke ............................................................................... 243
9.12.3 Press automatic .................................................................................... 247
9.12.4 N-break (press with N-PSDI mode) ...................................................... 250
9.13 User defined function blocks ....................................................................... 258
9.13.1 Grouped function block......................................................................... 258
9.13.2 Customized function block ................................................................... 262
9.14 Simulation of the configuration .................................................................... 265
9.15 Force mode ................................................................................................. 267
10. I/O modules ...................................................................................................... 271
10.1 Dual channel evaluation and discrepancy time monitoring ........................ 271
10.2 ON-OFF filter and OFF-ON filter ................................................................. 273
10.3 Disabling the test pulses of WS0-XTIO outputs .......................................... 273
11. Transferring the system configuration ............................................................... 274
11.1 Transferring project data to the safety controller ......................................... 274
11.2 Compatibility check ..................................................................................... 274
11.3 Verification of the configuration ................................................................... 275
11.4 Activating the write protection of the configuration in the
safety controller .......................................................................................... 278
11.5 Configuration checksums ............................................................................ 278
11.6 Deletion of the configuration in the safety controller ................................... 278
12. Device states of the MELSEC-WS safety controller ......................................... 279
12.1 Changing the device state .......................................................................... 280
12.2 Behaviour on startup ................................................................................... 280
12.3 Software reset of the CPU module ............................................................. 280
13. Technical commissioning .................................................................................. 281
13.1 Wiring and voltage supply ........................................................................... 281
13.2 Transferring the configuration ..................................................................... 281
13.3 Technical test and commissioning .............................................................. 282
To Next Page
Loading...
