Chapter 5
30
The graphical user interface
A double click on the CPU module in the configuration area will open the logic editor.
A double click on any network module in the configuration area will open the
network module configuration view for the respective network module.
Switch view
The Switch view button toggles between an enlarged and a reduced view of the
configuration area.
Settings
The Settings button opens a dialog where you can adjust the settings for your project.
Here you can …
create your own tag name format,
enable or disable customized elements (see Section 5.5.6),
enable or disable the import of customized function blocks,
enable or disable RS-232 routing for the CPU,
enable additional XT modules (see Section 5.5.1),
save the current view and/or activate a saved view.
change the path for the folders where user defined elements are saved,
export the module status bits as a CSV file, e.g. for use in a Programmable
controller.
Figure 4:
The “Hardware
configuration” view
Note
Figure 5:
Switch view button
Figure 6:
Settings button
To Next Page
Loading...
