4G9 ENGINE (E-W) -
Rocker Arms and Camshafts
11A-8-13
(15)Remove the lash adjuster from the container, then stand
the lash adjuster with its plunger at the top. Push the
plunger firmly and check that it does not move. Also,
check the lash adjuster’s height matches that of a new
lash adjuster.
NOTE
If lash adjuster contracts, perform the operations (13)
through (15) again to fill it with diesel fuel completely.
Replace the lash adjuster if it still contracts after performing
these steps.
(16) Stand the lash adjuster upright to prevent diesel fuel
spilling out. Do not allow the lash adjuster to become
contaminated by dirt or other foreign matter. Fit the lash
adjuster onto the engine as soon as possible.
PWEE9502-E
E
Dec. 1998Mitsubishi Motors Corporation Added
To Next Page
Loading...
