EasyManuals Logo

Mitsubishi MT300 User Manual

Mitsubishi MT300
305 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #98 background imageLoading...
Page #98 background image
Control
-
97
-
'10 HM-T-149
4.0 [N] Outdoor temp.
Menu 4.1 [N] Outdoor avg. temp.
This menu shows the average outdoor temperature according
to the set value in Menu 4.2 (factory setting: 24h).
Menu 4.2 [U] Outdoor filter time
Here you select during how long the average temperature in
Menu 4.1 is calculated.
Setting range: 1 min, 10 min, 1h, 2h, 4h, 6h, 12h, 24h
Default value: 24h
Menu 4.3 [U] Outdoor avg. 1min.
Shows the average outdoor temperature over the last minute.
Menu 4.4 [N] Return
Return to Menu 4.0.
5.0 [N] Heat pump
Menu 5.1 [N] Number of starts
The accumulated number of starts with the compressor in
outdoor unit is shown here.
Menu 5.2 [N] Run time compressor
The accumulated time that the compressor has been used in
outdoor unit is shown here.
Menu 5.3 [U] Time to start
Time until the compressor start in outdoor unit is shown in this
menu.
Menu 5.4 [U] Outdoor temp. Tho-A
This menu shows the outdoor air temperature that the heat
pump measures.
Menu 5.5 [U] Heat Ex Tho-R1
This menu shows the evaporator temperature in the heat pump
at sensor Tho-R1.
Menu 5.6 [U] Heat Ex Tho-R2
This menu shows the evaporator temperature in the heat pump
at sensor Tho-R2.
Menu 5.7 [U] Suction temp. Tho-S
This menu shows the suction gas temperature in the heat pump.
Menu 5.8 [U] Hot gas Tho-D
This menu shows the hotgas temperature in the heat pump.
Menu 5.9 [U] Liquid line temp.
This menu shows the liquid line temperature in the heat pump.
Menu 5.10 [U] Condensor out / max
Shows the current and max. allowed temperature after the
condenser.
Menu 5.11 [U] HP
The current high pressure and corresponding temperature
during heating are shown here. During cooling, the actual low
pressure and corresponding temperature are shown.
Menu 5.12 [U] LP LPT
The current low pressure is shown here.
Menu 5.13 [U] Fan speed
The fan speed is shown here.
Menu 5.14.0 [U] CompFreq act/set
The actual and set point value for the compressor frequency
are shown here.
Menu 5.14.1 [U] OU current CT
The present phase current to outdoor unit is shown here.
Menu 5.14.2 [U] Inverter temp Tho-IP
The current inverter temperature is shown here.
Menu 5.14.3 [U] Return
Return to Menu 5.14.0.
Control

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mitsubishi MT300 and is the answer not in the manual?

Mitsubishi MT300 Specifications

General IconGeneral
BrandMitsubishi
ModelMT300
CategoryHeat Pump
LanguageEnglish

Related product manuals