Appendix
01/02 AWB8230-1415GB
190
Digital control inputs programmable as • REV: Start/stop anticlockwise operation
• FF1 to FF4: Fixed frequency selection
• JOG: Jog mode
• DB: DC braking active
• SET: Second parameter set active
• 2CH: Second time ramp
• FRS: Free run stop
• EXT: External fault message
• USP: Unattended start protection
• CS: Heavy mains starting
• SFT: Software protection
• AT: Use setpoint value 4 to 20 mA
• SET3: Third parameter set active
• RST: Reset
• STA: Pulse start (3-wire)
• STP: Pulse stop (3-wire)
• F/R: Direction (3-wire)
• PID: PID control active
• PIDC: Reset integral component of PID control
• CAS: Tacho-generator with vector control
• UP: Remote access, acceleration
• DWN: Remote access, deceleration
• UDC: Reset frequency with remote control
• OPE: Setpoint value through operator panel
• SF1 to SF7: Bitwise fixed frequency selection
• OLR: Change over current limit
• TL: Torque limitation active (only with vector control)
• TRQ1: Torque limitation 1 active (clockwise, in drive mode)
• TRQ2: Torque limitation 2 active (anticlockwise, regenerative)
• PPI: P- or PI control (only with vector control)
• BOK: Brake enable confirmation
• ORT: Direction of rotation (only with optional DE6-IOM-ENC module)
• LAC: Ramp function Off
• PCLR: Delete positioning deviation (only with optional DE6-IOM-ENC module)
• STAT: Setpoint definition through module (only with optional DE6-... module)
• NO: No function
Outputs
Digital signalling outputs
programmable as
• RUN: Motor operational
• FA1/FA2: Frequency reached/exceeded
• FA3/FA4/FA5: Frequency reached (1)/frequency exceeded (2)/frequency reached (2)
• OD: PID deviation exceeded
• OL: Overload
• AL: Fault
• QTQ: Torque reached/exceeded
• IP: Mains failure
• UV: Undervoltage
• TRQ: Torque limitation
• RNT: Running time exceeded
• ONT: Mains On time exceeded
• THM: Motor thermal overload
• BRK: Enable signal for external brake
• BER: Brake fault
• ZS: Zero speed (only with optional DE6-IOM-ENC module)
• DSE: Speed deviation exceeded (only with optional DE6-IOM-ENC module)
• POK: Positioning (only with optional DE6-IOM-ENC module)
• OL2: Overload alarm 2
DV6-340-...
22K 30K 37K 45K 55K 75K 90K 110K 132K
For Moeller Electric Sales and Support call KMparts.com (866) 595-9616
To Next Page
Loading...
