7 Description of Function Codes NICE5000 User Manual
- 158 -
Bit Function Description Default
Bit8
Fire emergency
indicator blinking
at re emergency
2
These functions control the re emergency indicator and
tone in reghter state.
The following conditions are required to implement the
functions:
Install the HCB-B.
Set the functions of the HCB-B output terminals in group
FL parameters.
Connect the re emergency components to the
corresponding output terminals.
1
Bit9
Fire emergency
indicator steady
ON at re
emergency 2
0
Bit10
Fire emergency
tone prompt at
intervals at re
emergency 2
1
Bit11
Exiting reghter
operation state at
any oor
If this signal is active, the elevator can exit the reghter
operation state at any oor.
0
F6-19 Fire emergency function selection 3
Bit0
Nearest call
mode
The elevator responds to the call from the oor nearest
to the current oor rst. In addition, the call in the same
direction takes precedence over the call with the same
distance.
Multiple calls can be registered.
This mode has the highest priority.
0
Bit1 First call mode
The elevator responds to the call rstly registered in re
emergency state. This call can be cancelled by pressing
the button twice.
This mode has the medium priority.
0
Bit2 Last call mode
Only one car call can be registered in reghter operation
state. The later one overwrites the previous one.
This mode has the lowest priority.
1
Bit3 to
Bit4
Reserved
- 0
Bit5
Call registered
by holding down
button
The car call is registered only when you holding down the
button and release it after door close limit.
0
Bit6
Closing door by
holding down the
door close button
In the re emergency state, the door close process can
be completed only by holding down the door close button
until the door close limit is reached. Otherwise, it will be
switched over to door open automatically.
0
Bit7 Reserved
- 0
Bit8
Door close at car
call active
In the re emergency state, the elevator automatically
closes the door when there is a car call.
1
Bit9 Reserved
- 0
Bit10 Reserved
- 0
Bit11
Automatic door
open at arrival
In reghter operation state, the elevator automatically
opens the door at arrival.
0