3 For the Source Radio, perform the following actions:
a Press the Menu/OK → Advanced → Cloning →
Radio Cloning
b Place the Source Radio in its SUC.
c Press the Menu/OK button.
The display shows Cloning....
If successful:
• The display shows Cloned Successfully.
If unsuccessful:
• The display shows Cloning Failed.
4 After completing the cloning process, exit the
'cloning' mode by long pressing the Home/Back
button.
Troubleshooting Cloning Mode
In the event that cloning fails, perform each of the following
steps before attempting to start cloning process again.
1 Ensure that the batteries on both radios are fully
charged and engaged properly on the radio.
2 Check the cloning cable connection on both Single-
Unit Chargers (SUC).
3 Ensure that there is no debris in the charging tray or
on the radio contacts and the radio contact is
touching the SUC or MUC contact firmly.
4 Ensure that the Target Radio is turned on.
5 Ensure that the Source Radio is in cloning mode.
6 Ensure that the two radios are both from the same
frequency band, and same region.
NOTICE:
This cloning cable is designed to operate only
with compatible Motorola Solutions SUC.
When ordering cloning cable kit, refer to part number
HKKN4028_. For more information about the accessories,
see Accessories on page 73.
Cloning PROFILE ID Number Through
Wireless
The PROFILE ID Number Wireless Cloning feature is
useful when you want to clone the PROFILE ID Number for
English
48