EasyManuals Logo

Motorola solutions DTR600 User Manual

Motorola solutions DTR600
158 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #47 background imageLoading...
Page #47 background image
3 Exit the 'cloning' mode by long pressing the Home/
Back button.
4 If cloning fails, refer to Troubleshooting Cloning
Mode on page 48.
When ordering the MUC, refer to P/N# PMPN4465_.
NOTICE:
User should not remove the radios from the
MUC when cloning is on-going.
Cloning Radio Using Two SUCs and a
Radio-to- Radio Cloning Cable
(Optional Accessory)
Before starting the cloning process, ensure that you have
the following hardware:
A Cloning Cable (P/N# HKKN4028_).
A fully charged battery in each of the radios.
Two Single-Unit Chargers (SUC) for radio cloning.
Ensure that the radios are turned on.
Figure 6: Radio to Radio Cloning
1 Plug one side of the cloning cable micro-USB
connector to the first SUC and the other end to the
second SUC.
NOTICE:
During the cloning process, no power is being
applied to the SUC. The batteries are not
charged. Only data communication is being
established between the two radios.
2 Turn on the Target Radio and place it into one of the
SUCs.
English
47

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Motorola solutions DTR600 and is the answer not in the manual?

Motorola solutions DTR600 Specifications

General IconGeneral
BrandMotorola solutions
ModelDTR600
CategoryTwo-Way Radio
LanguageEnglish

Related product manuals