all the radios in your fleet but you do not want to clone
particular radio settings that may be unique for each radio
(like Programmable button configuration, Microphone
Gain, Radio Name and others). It is also useful if you do
not have a programming cable, or PC available to use with
the Customer Programming Software (CPS) configuration.
The Profile ID feature is enabled through CPS
configuration.
1 Power the Target Radio and perform the following
actions:
a Press the Menu/OK → Advanced → Cloning →
Prof. ID Cloning.
b Press the Menu/OK button.
The display shows Profile Clone Mode On.
2 Power the Master Radio and perform the following
actions:.
a Press the Menu/OK → Advanced → Cloning →
Prof. ID Cloning.
b Press the Menu/OK button.
The display shows Profile Clone Mode On.
c Press the Menu/OK button.
The display shows Profile ID Cloning...
If successful:
• The display shows Cloned Successfully.
If unsuccessful:
• The display shows Cloning Failed.
NOTICE:
• If target radio shows Cloning Failed using
Wireless Cloning feature, try again with distance
of at least 1 ft away from source radio.
Over The Air Contact Cloning
Over the Air (OTA) Contact Cloning feature allows you to
add or delete contacts to or from another radio wirelessly
without connecting the radios by cable.
You can clone over either private, private group, or public
group while the targeted slave radio contact can be either
private or private group. OTA contact cloning feature is
enabled through Customer Programming Software (CPS)
configuration.
English
49
To Next Page
Loading...
Need help?
General
