Cloning Mode
You can clone radio profiles from a Source radio to a
Target radio.
Use the following devices/tools to perform Cloning Mode:
• Multi-Unit Charger (MUC) – Optional accessory
• Two Single Unit Chargers (SUC) and a Radio-to-Radio
cloning cable - Optional accessory
• Customer Software Programming (CPS) – Free
software download
• Wireless PIN cloning
Contact your dealer for more information.
Cloning with a MUC (Optional
Accessory)
To clone radios using the Multi-Unit Charger, you must
obtain at least two radios:
• A fully charged battery in each of the radios.
• a Source radio (radio from which the profiles are cloned
or copied).
• a Target radio (radio to which the profiles are cloned
from the source radio).
The Source radio has to be in Pocket 1 and 2, while the
Target radio has to be in Pocket 4 and 5, matching in
the MUCs pockets by pairs as follows:
- 1 and 2
- 4 and 5
MUC pockets numbers should be read from left to right
with the Motorola Solutions logo facing front.
Paired Target radios and Source radios must be of the
same band type in order for the cloning to run
successfully.
When cloning, the MUC does not need to be plugged
into a power source, but all radios require charged
batteries.
English
45
To Next Page
Loading...
Need help?
General
