Parameter Editing Keys Value
Use keypad to enter hexadecimal numbers:
• Plus, multiple press 2 to scroll through A, B, C, 2.
• Plus, multiple press 3 to scroll through D, E, F, 3.
Rx Type Perform one of the following:
• or to toggle between valid entries.
• Press the keypad digits for quick access to locations in
the list.
ANALOG/
DIGITAL/
MIXED
Tx Type ANALOG/
DIGITAL
Bandwidth 25kHz/
20kHz/
12.5kHz
Protect ON/OFF
Tx Deviation 5.0 kHz/4.0
kHz/2.5 kHz
Power Level High/Low
Hot Keypad ON/OFF
Busy LED ON/OFF
Low Batt
LED
ON/OFF
MPL Enable Disabled/Rx
/Tx/All
Scan List None/Scan
List 1, 2,
3,...
Zone Name Use keypad to enter numbers and alphabet characters. For more informa-
tion, see Keypad on page 21.
Top Chan
Name
Top Zone
Name
Chan Name
NOTE:
To edit Tx PL, Rx PL, Tx DPL, and Rx DPL, the PL Setting must be set to Disabled.
If PL setting is set to ALL, Rx or Tx, there is no Edit selection available to change the
codes for Tx PL, Rx PL, Tx DPL, or Rx DPL.
If PL setting is set to Rx, you can only edit Tx PL and Tx DPL codes.
If PL setting is set to Tx, you can only edit Rx PL and Rx DPL codes.
MN006147A01-AE
Chapter 6: Advanced Features
131
To Next Page
Loading...
Need help?
General
