Motorola MTP8000Ex Series - Status Remote Control; Setting Remote Control; Man down

5.8.10
Status Remote Control
Status Remote Control is a feature that provides limited control of the radio (unlike SDS Remote
Control) because it uses only status messages, not SDS messages.
NOTICE: Only one type of remote control can be active on a radio: either SDS or Status.
This feature is not supported by the Dimetra system.
The following tasks can be assigned remotely to a radio:
Play loud tone until user interaction
The radio plays a loud tone as in the Man Down feature until you unlock the keypad (if needed) and
press the appropriate soft key (labeled Exit). The tone is played via the speaker even if an
accessory is attached.
NOTICE: The tone is not emitted when the radio is in one of the following states:
•
in a call
• temporarily disabled
• Covert Mode
• Emergency Mode
• Silent Emergency Mode
• Pseudo Off Mode
• Ambience Listening Mode
• TXI Mode
Send firmware version and TEI
The radio sends back an SDS message with its firmware version and TEI.
NOTICE: If the sending Individual Short Subscriber Identity (ISSI) is not on the Allowed ISSIs
list, the receiving radio ignores the task.
5.8.11
Setting Remote Control
This procedure describes how to toggle remote control.
Following this procedure toggles the type of remote control enabled by your service provider – either
SDS or Status Remote Control.
Procedure:
1 From the home screen, press the MENU
key.
2 Select Security → Remote Control.
3 Select On to enable, or Off to disable remote control.
5.9
Man Down
NOTICE: This is a selling feature.
Man Down alerts when no movement occurs for a set time or the radio stays at an angle of tilt below a
defined value. The radio alerts you when:
•
its tilt exceeds a predefined angle value.
MN002041A01–AA
Chapter
5: Main Menu
112 Send Feedback