2 Select RUI
→ Log off.
3 Press Accept.
5.17
Networks
This menu item allows you to switch between the radio operation modes.
5.17.1
Selecting Network Operation Mode
Procedure:
1 From the home screen, press the MENU key.
2 Select Networks.
3 Select one of the following:
• Networks Sel – Selects the network to which the radio is allowed to register.
• Trunked Mode – Switches to the mode using infrastructure.
• Direct Mode – Switches to the mode without using infrastructure.
• Repeater Mode – Switches to the Repeater Mode.
• TXI Mode – Select Activate to stop sending any radio transmission.
NOTICE: If the radio is in TXI Mode, it is not possible to switch from Direct Mode to
Trunked Mode.
NOTICE: If the radio is in TXI Mode, it is not possible to switch from Direct Mode to
Trunked Mode or Repeater Mode.
5.17.2
Selecting Your Network
Procedure:
1 From the home screen, press the MENU key.
2 Select Networks
→ Networks Sel → Home Only.
3 Your radio registers to the home network. If several home networks are defined, the radio
registers to the first available network on the list.
5.17.3
Using the Select Net Registration
When and where to use: Use this feature to migrate to another predefined network, when you are out
of the range of your network and your radio displays the No Service message.
Procedure:
1 From the home screen, press the MENU key.
2 Select Networks → Networks Sel → Select Net.
MN002041A01–AA
Chapter
5: Main Menu
Send Feedback 139
To Next Page
Loading...
