5.10.8.4
Setting the Date Format
Prerequisites: If
MENU → Setup → Time & Date → Display is set to Time & Date or Date Only.
Procedure:
1 From the home screen, press the MENU key.
2 Select Setup → Time & Date → Format → Format Date.
3 Select (D — day, M — month, Y — year):
• DD/MM/YY
• MM/DD/YY
• DD-MON-YY
• YY/MM/DD
5.10.8.5
Setting the Date Manually
When and where to use: If the time cannot update automatically through the infrastructure.
Procedure:
1 From the home screen, press the MENU key.
2 Select Setup → Time & Date → Set → Set Date.
3 Enter current time using NAVIGATION keys or keypad.
4 Press Done.
5.10.8.6
Setting Time Offset
Procedure:
1 From the home screen, press the MENU key.
2 Select Setup → Time & Date → Set → Time Offset.
3 Enter time offset using NAVIGATION keys.
NOTICE: You can adjust the offset value, with 15 minute steps, up to 14 hours ahead or
behind.
4 Press Done.
5.10.8.7
Setting Automatic Updates for the Time and Date
Procedure:
1 From the home screen, press the MENU key.
2 Select Setup → Time & Date → System Update.
3 Select one of the following:
• Off — All the infrastructure informations are ignored. The radio uses internal time and offset.
• Time Only
— Time displayed is calculated from the offset programmed by your service
provider added or subtracted from the infrastructure time.
MN002041A01–AA
Chapter
5: Main Menu
Send Feedback 123
To Next Page
Loading...
