2.2.1
Attaching the Antenna
Procedure:
1 Insert the screw-in base of the antenna into the antenna terminal on the top of the radio.
2 Turn clockwise until snug.
NOTICE: Use only the antenna intended for the radio. Use of other antennas can result
in significant range loss due to poor RF performance.
2.2.2
Installing the SIM Card
IMPORTANT: The following procedure must be performed only in non-hazardous environment.
Prerequisites:
Your radio is equipped with a SIM/microSD card slot.
Prepare T-5IP TORX – PLUS screw bit and 1.0 +0.1/-0.1 in-lbs
torque screwdriver.
Procedure:
1 Remove the battery.
2 Unscrew the M2 countersunk 5IP TORX – PLUS screws that secure the SIM card door to the
chassis.
3 Remove the SIM card door .
MN002041A01–AA
Chapter 2: Getting Started
24 Send Feedback
To Next Page
Loading...
