Motorola MTP8000Ex Series - Standard Home Group; Scan; Activating Talkgroup Scanning; Setting Talkgroups in the Active Scan List

5.11.1.1
Standard Home Group
This menu item allows you to configure the standard home group to be used during start up and when
changing modes: TMO –> DMO and TMO –> Repeater.
5.11.2
Scan
This menu item allows you to activate/deactivate scanning, view the active scan list, and edit the scan
lists. This feature is available only for the TMO Mode. Your radio joins any group call as long as this
group is defined in the scan list and scan is turned on.
5.11.2.1
Activating Talkgroup Scanning
When and where to use: If you want to monitor any TMO Group Call in the defined talkgroup list.
Procedure:
1 From the home screen, press the MENU key.
2 Select Group Setup → Scan → Scanning.
3 Select Select List and then a list name.
Your radio displays list name Selected.
4 Select Scanning
→ On.
Your radio is scanning on the predefined scan list.
5.11.2.2
Setting Talkgroups in the Active Scan List
When and where to use: If you want to edit talkgroups in the active scan list.
Procedure:
1 From the home screen, press the MENU key.
2 Select Group Setup → Scan → Active List.
NOTICE: If Scanning is Off is displayed, go to Group Setup → Scan → Scanning →
On to enable scanning.
3 Select View and highlight the required talkgroup.
4 Press MENU.
5 Select one of the following:
• Delete — Erases this group from the active scan list.
• Priority and select new priority to Low, Medium
or High.
5.11.2.3
Setting Scan Lists
When and where to use: If you want to set up any scan list.
Procedure:
1 From the home screen, press the MENU key.
MN002041A01–AA
Chapter 5: Main Menu
130 Send Feedback