5.10.2
Set Volume
This menu item allows you to adjust the Simplex, Duplex, Earpiece, Speaker, and Keypad tone
volume.
This menu item allows you to adjust the Speaker and Earpiece tone volumes.
5.10.2.1
Setting Volume
Procedure:
1 From the home screen, press the MENU key.
2 Select Setup → Set Volume.
3 Select Speaker
or Earpiece.
4 Select one of the following:
• Voice Vol – sets the volume level for voice.
• Duplex Vol – sets the volume level for duplex ringtones.
• Simplex Vol – sets the volume level for simplex ringtones.
• Keypad Vol – sets the volume level for keypad tones.
• Tones Vol – sets the volume level for alert tones.
• Call-Out Vol – sets the volume level for Call-Out tones (if enabled).
NOTICE: If the display shows only one option Volume, you can adjust all of the above
settings at once. You have the option to change the settings individually when the
Volume Adj. Mode is set to Individual.
5 Press right or left NAVIGATION key to change the value.
5.10.3
Language
This sub-menu allows you to change the language of the radio.
5.10.3.1
Setting Language
Prerequisites: The list of available languages is set by service provider.
Procedure:
1 From the home screen, press the MENU key.
2 Select Setup → Language.
3 Select desired language.
5.10.4
Data Setup
This menu item allows you to set up your radio to transmit and receive data from the external device.
To connect your radio accessory connector to the external device, use the
PMKN4159 (Serial) or
PMKN4160 (USB) cable. The external device must run an application complying with the TETRA
standards.
MN002041A01–AA
Chapter 5: Main Menu
114 Send Feedback
To Next Page
Loading...
Need help?
General
