NOTICE: This feature is not supported on Dimetra networks.
5.3.9.4
Sending Targeted Status Messages
Procedure:
1 From the home screen, press the MENU key.
2 Select Messages
→ Send Status.
3 Do one of the following:
• Highlight the required status message and press Select, the PTT button, or the SEND key.
• If the status list is empty, enter a 5 digit status message number and press Send.
4 Highlight the required status message and press Select, the PTT button, or the SEND key.
5 Do one of the following:
• Enter the number or press abc to select the name from your contact list. Press Send.
• Select required talkgroup from the TalkGroup List.
The display shows one of the following delivery reports:
• Status Sent.
• Status Failed.
5.3.10
Additional Address
The Additional Address feature allows the radio to send RMS messages, and Local Information
Protocol (LIP) reports to additionally defined recipients.
The default addresses where the radio sends RMS messages and LIP reports are defined by your
service provider. If an Additional Address is selected and enabled, RMS messages and LIP reports are
also sent to the recipient defined in the Additional Address.
You can create, edit, and delete Additional Addresses using the radio menu. If an Additional Address is
configured by your service provider, the service provider can disable edition and deletion of the
address using the radio menu.
You can define up to 30 Additional Addresses.
5.3.10.1
Enabling/Disabling Additional Address
Procedure:
1 From the home screen, press the MENU key.
2 Select Messages → Additional Address → Enable.
3 Select one of the following:
• On – to activate the feature
• Off – to deactivate the feature
MN002041A01–AA
Chapter 5: Main Menu
Send Feedback 91
To Next Page
Loading...
Need help?
General
