Check Interval
Setting Description Factory Default
20 to 1000 (ms) Specify the interval at which the device will probe the AP. 50
Retry Count
Setting Description Factory Default
3 to 10
Specify the maximum number of times the device will probe
the AP.
3
Expiry
Setting Description Factory Default
100 to 10000 (ms.)
Specify the connection expiration interval (in ms). If
exceeded, the client will consider the AP unreachable or
unresponsive, and will trigger the recovery mechanism.
1000
Threshold Indicate
Use SNR as the threshold indicator.
SNR
Use signal strength as the threshold indicator.
5 GHz: SNR Candidate Threshold (for SNR)
Specify the SNR roaming threshold.
2.4 GHz: SNR Candidate Threshold (for SNR)
Specify the SNR roaming threshold.
5 GHz: Signal Strength Candidate Threshold (for Signal Strength)
Specify the signal strength roaming threshold.
2.4 GHz: Signal Strength Candidate Threshold (for Signal Strength)
Specify the signal strength roaming threshold.
NOTE
The SNR and signal strength thresholds are used to determine when the AWK will start looking for a better
AP to associate with. If the current connection quality to the AP (based on SNR or signal strength) is lower
than the specified threshold value, the client will start looking for other suitable wireless devices.
When finished, click APPLY.
Remote Host Check
When enabled, this recovery mechanism is triggered when IP traffic fails to reach the configured remote
host. The mechanism works by checking if the remote host is reachable at the defined check interval. If the
host is still unreachable after the specified number of retries, the client will disconnect from the current AP
and will attempt to associate with another AP.
To Next Page
Loading...
Need help?
General
