Bolt X Quick Start Guide
23
Red (Overvoltage) Stop running the robot and contact MRMC
at support@mrmoco.com.
Note
The LCD monitor, for the regenerative protection voltage settings, is
inside the base behind the fan assembly panel. The voltage setting is
preset by MRMC, to switch in the regenerative resistors, when the
voltage rises above 435VAC 3 phase, under a regenerative event.
DO NOT press the buttons on the display. In case of a fault contact
MRMC at support@mrmoco.com. It is important that the Bolt X is
connected to a supply strictly 400/415VAC. A voltage applied greater
than 435VAC will result in the regenerative resistors being switched
on and cause an over temperature condition.
LED Description
To Next Page
Loading...