Bolt X Quick Start Guide
38
Checking when YRC1000 is ready
After powering, the YRC1000 controller should successfully boot within 2
minutes, then start Flair. If Flair doesn’t connect, undo the screws on the
pendant hatch plate at the lower right corner in the base.
Remove the pendant bypass and plug in the pendant.
After switching on YRC1000, on the pendant, in the Job
menu, make sure no error message is displayed at the
bottom of the screen. (Function buttons should be blank.)
Pendant hatch
plate
Bypass jumper
Blank Function buttons
Job menu
To Next Page
Loading...