Bolt X Quick Start Guide
31
Using Bolt X without Track (with Weight Plates)
1. Ensure that the Bolt X is not on track and can be wheeled on its
jacking castors.
2. Lay the first weight plate on the floor, in a position that will be the
rear of the Bolt X turret, across the “facing front” direction.
3. Lay the second weight plate on the floor in front of this and carefully
position it so the threaded holes along the long centre axis of the
plate are 800mm apart between the two plates. Do not use the
floating retainers as they are inexact and are used only for fitting
rail.
4. Add the supplied 4 x ramps to the first weight plate the Bolt X will
be wheeled on to.
800mm
Floating retainers
Screw holes that
should line with
screw cavities on
Bolt X base
800mm
Ramps
To Next Page
Loading...