MULTILIFT XR S - Page 125

XR21S59 CHU 125
1/2018
113813003
Hooklift Multilift XR21S59 CHU
User Manual
M
A
A
15A. Driving the hook frame during loading
(only in manual mode A5).
Choose manual mode A5, push the A5 button for approx. 2 s.
- green signal light ”power on” is lit on the stowage control unit.
Drive the horizontal movement cylinder out
- by pushing the front button in the bottom row on the either side of the control
unit.
Release the button when the front of the container if high enough o󰀨 the ground
not to collide too early with the rear rollers.
Continue loading the container in automatic mode A3 after lifting it.
If you performed phase 15A, please choose automatic mode A3 again
- “power on” signal light on the stowage control unit goes out.
16. Middle frame forward
- move the control lever to front position
- the main cylinder piston rods move inwards.
17. Activate the handbrake when the rear end of the container is lifted from the
ground.
When the container is safely on the rear rollers, load the entire container onto the
frame.
18. Middle frame forward (end of the movement),
- keep the control lever in front
- main cylinder piston rods move inwards.