XR21S59 CHU 139
1/2018
113813003
Hooklift Multilift XR21S59 CHU
User Manual
Moving the liftframe onto the XR21S stowage
MIDDLE FRAME OF THE XR21S EQUIPMENT RESTS ON THE SUB FRAME AND
THE LIFTFRAME IS IN THE GRIPPING HOOK WHEN STARTING MOVEMENTS
It is recommended to let the engine run idle during
the stowage movements.
1. Check and, if necessary, push the locking shafts on the lower parts of the
liftframe to the STOWED position.
2. Engaging the stowage mode A4
Choose mode A4
2.1 push the A4 button shortly
2.2 code ”A4” is lit on the XR21S equipment control unit display
2.3 green signal light ”power on” is lit on the stowage control unit.
If it seems impossible to select the mode and code ”d019” is displayed on the
control unit, make sure that the attachment joints of the liftframe ratchets
are attached to the stowage.
3. Activate the handbrake.
4. Engage the hydraulic pump.
5. Moving the liftframe from the XR21S -gripping hook to the stowage
Code ”A4” is visible on the XR21S equipment control unit display.
Green signal light ”power on” on the stowage control unit is lit.
Press the STOW button on the stowage control unit without releasing it:
5.1 Body locks open if they are still closed.
5.2 Horizontal movement moves to the stow/unstow position
horizontal movement stops in its far-front position.
>>>
To Next Page
Loading...