MULTILIFT XR S - Page 57

XR21S59 CHU 57
1/2018
113813003
Hooklift Multilift XR21S59 CHU
User Manual
M
CXXX / dXXX
>>>
M
A
Safety codes
7. Check that the body locks are
engaged
- the hydraulic locks are engaged
- check that the body locks are
engaged by pressing the
”bodylocks closed” button for
approx. 2 seconds before starting
the tipping movement
- the body lock signal light should
not be lit
- the middle/rear frame (= tipping
lock) must be closed
- under-run bar is retracted,
if it is not in
- URB signal light on the control
unit is lit, when the under-run bar
is fully in the in position.
7. Checking body locks
- move the control lever slowly
backwards
- under-run bar is retracted,
if it is not in
- URB signal light on the control
unit is lit, when the under-run bar
is fully in the in position
- the system will close the body
locks, if they are open
- “locks not closed” signal light
should not be lit
 -themiddle/rearframe(=tipping
lock) must be closed.
8. Raise the tipping device
(middle frame together with the
rear frame) into the desired or the
maximum tipping angle
- move the control lever slowly
backwards
- make sure the atrack/body doesn’t
hit the rear bumper or the ground
- ”frame not down” signal light is lit,
when the middle frame is lifted o󰀨
the sub frame
- stop the movement by releasing the
control lever.
8. Raise the tipping device
(middle frame together with the
rear frame) into the desired or the
maximum tipping angle
- keep the control lever back
 -makesuretheatrack/body
doesn’t hit the rear bumper or the
ground
- ”frame not down” signal light is lit,
  whenthemiddleframeisliftedo
the sub frame
- stop the movement by releasing
the control lever.