Operating the transmitter using the PC
7.5 Model flying simulator
You can use the PROFI TX to control a model flying simulator in two ways:
Via USB cable
Via M-LINK in conjunction with the MULTIFlight stick
In both cases, you have the following options:
Would you like to work in simulator mode without configuring "Travel",
"Expo" and "Trim"?
Switch ON "Training" in the Setup > Training menu (see page 96).
Select the Student mode. In this case, only unprocessed stick signals are
used for controlling. It is not relevant which model memory is used. Only
the stick assignment must match (see "Ctrl Mode" on page 101).
Would you like to use "Trim", "D/R", "Expo", "Combi-Switch" and "Ctrl.Mix"?
Create a new model using the BASIC template (page 155) and change the
model name (page 157), e.g. to Simulator. Safety check can be
switched off.
From now on, use this model memory for simulator mode.
Would you like to use "Expo", "D/R", "Trim", and "Combi-Switch" for the
simulator?
Create a new model memory based on the BASIC template (page 155).
Change the model name (page 157), e.g. to Simulator.
Alternatively, you can copy the memory of a suitable model. Change the
model name to avoid mix-ups. Do not use the memory of a real-world
model: Settings that you configure for the simulator mode will not
automatically suit your real-world model.
In simulator mode, all the functions on the servo side (mixers, curves, reverse)
are switched off.
To Next Page
Loading...
Need help?
General
