Glossary of technical terms
Glossary of technical terms
Allocation
Permanently assigning a set value to a digi-adjuster.
Assignment
Defines which functions in the transmitter or model are controlled by which control.
Battery management
Determines the remaining operating time (time to empty), the capacity and other
battery data from the current and voltage characteristics. Optimises the charge /
discharge limits for a long battery life.
Binding
Required to ensure that the receiver exclusively responds to signals from "its"
specific (bound) transmitter. The binding procedure must be performed during
initial setup.
Re-binding is required if the transmitter mode is changed (e.g. response is
changed from "Fast" to "Normal", frequency range is changed from "Normal"
to "France").
Centre trim
Trim corrections do not change the end-points.
Combi-Switch
Couples aileron and rudder in a way that allows both of the control functions
to be controlled by either of the functions. This makes it easier to fly accurate
turns.
Control
Any transmitter control which can be assigned to a control function or switched
function:
o Sticks
o Slide potentiometers
o Rotary potentiometers
o Switches and their designated buttons
To Next Page
Loading...
Need help?
General
