5.5.1.1 Combi-Switch
The Combi-Switch couples aileron and rudder in a way that allows both of the
control functions to be controlled by either of the functions. This makes it easier to
fly accurate turns.
The Combi-Switch can be configured for specific flight phases. You define the
associated switch in the Setup > Assign.Switches menu using the CS/DTC
parameter (see section 5.3.6 "Assign.Switches" on page 102).
Ail > rudder or Ail < rudder
Percentage of the respective control function (%).
Increment: 2%
Adjustment range:
Switch
The switch used and its respective switch position are displayed here.
(In the example: <2, on the left side of the transmitter, # = switched on when
back)
5.5.1.2 Differnt.Ail
You use the Differnt.Ail menu to configure the aileron differential. Refer to
section 8.1.3.1 "Configuring aileron differential" on page 183 for differential
information.
To Next Page
Loading...
