1.3 About these operating instructions
These operating instructions describe the PROFI TX tray-type transmitter and
contain the following chapters:
Chapter 1 "Introduction" provides an overview of the
PROFI TX concept.
Chapter 2 "Safety instructions" contains important information concerning
safety, intended use and warranty.
Chapter 3 "Transmitter" describes:
o The PROFI TX hardware.
o How to setup the transmitter for operation.
o Mechanical operations that may have to be carried out on the
transmitter, e.g. for installing additional controls.
o How to charge the transmitter battery including battery
management.
o How to switch the transmitter on and off.
o How to perform a range check and the binding procedure.
o How to operate in trainer mode.
o How to trim your model aeroplane.
Chapter 4 "Model templates" describes the model templates available in
the PROFI TX.
Chapter 5 "Menus" describes the software used in the PROFI TX:
o Navigation within the software.
o The status displays.
o All menus and their parameters.
Chapter 6 "Operating the transmitter" describes:
o How to operate the transmitter and software by means of the
keypad, the central wheel and, if necessary, the optional digi-
adjusters.
o How to assign controls and switches. This defines which controls
are used to operate the various functions in the transmitter or
model.
Chapter 7 "Operating the transmitter using the PC" describes how to
connect the transmitter to the PC and the options provided by this
connection.
To Next Page
Loading...
