Operating the transmitter using the PC
7.5.1 Via USB cable
If the PROFI TX transmitter is operating in normal mode and is connected to the
PC via USB cable, it logs into the PC as a game controller. Upon first time use,
Windows automatically installs the required drivers. This may take several minutes.
Neither the transmitter nor the PC must be switched off while the driver installation
is in progress.
Once the installation is completed, the "Devices and Printers" menu contains the
following additional entry:
If you are using our MULTIFlight simulator, no further steps are required.
Calibration and assignment of the control channels match automatically.
For other simulators, you may have to perform a calibration and assign the control
functions.
To Next Page
Loading...
Need help?
General
