Munters Trio Poultry Controller - Page 148

© Munters AB, 2020 148
17 Lighting Program
TRIO supports on/off (non-dimmable) lights and dimmable lights. In setting up the program, the following
options have to be defined:
•
On/Off and/or 0 – 10 Volt Variable Lights (defined in Lighting Devices, page 74). A system
can include both.
•
Single line or multiline control: In single line control, all light lines have the same output. In
multiline control, the user defines the value (on/off or intensity level) for each line.
•
Time: Starting time for each lighting event.
•
If a light sensor is installed, an alarm can be generated if the light goes below a certain
intensity.
•
On/Off Lights
•
0 – 10 Volt Variable Lights
•
Light Settings
17.1 On/Off Lights
1. To enable multi line control, go to Control > Light > Settings and enable Multi Line Control
(option).
2. Go to Control > Light.