Munters Trio Poultry Controller - Page 55

© Munters AB, 2020 55
•
Outside temperature: The temperature sensor defined as an outside temperature is not included
in any average calculation.
Map specific temperature sensors to specific devices.
•
Go to System > Temperature Definition.
•
Map the sensors to devices.
o
Define which sensors are used to calculate the average temperature.
o
Define an outside temperature sensor (if required).
NOTE Uninstalling a device in the Relay Layout, Analog Output or TRIAC tables removes the device from
this screen.
7.2.3 E
NABLING A
W
EATHER
S
TATION
To say costs on temperature sensors, one outdoor temperature sensor can provide data to the entire TRIO
network.
NOTE Install and map one outdoor sensor only.
1. In System > Device and Sensors, define one sensor as Outside Temperature.
2. Go to System > Control Strategy > Weather Station .