For your own safety
User manual 57106_hdb_en_13 9 / 94
2 For your own safety
2.1 Target group
Users This manual is intended for users who have knowledge of automation sys-
tems.
Documentation Please give this manual to all employees involved in the following tasks:
Planning
Installation
Set-up
Operation
2.2 Intended purpose
Designated use The Cube20S system has been designed and manufactured for:
communication and process control
general control and automation tasks
industrial use
operation under the ambient conditions specified under technical data
installation in a switch cabinet
Foreseeable misuse The device is not approved for being used:
in potentially explosive atmospheres (EX Zone)
outside of switch cabinets.
2.3 General safety instructions
Please note:
the relevant safety and accident prevention regulations;
the EC Directives or other national regulations;
generally recognized safety rules;
the section 2.5 "EMC installation guidelines".
NOTICE
Defective device!
Improper use of hardware and software can cause damage to the device.
Only qualified personnel of Murrelektronik GmbH may manipulate the de-
vice.
Use the device only to the extent described in the manual.
Avoid accidents caused by electrical voltage!
Comply with the 5 safety rules of electrical engineering!
Disconnect the device from the mains.
Then carry out installation or repair work.
Avoid personal injury and material damage due to malfunctions!
Provide external circuit breakers.
The device may only be operated within the specified tolerances.
To Next Page
Loading...
Need help?
General
