Configuration/settings
User manual 55170_hdb_en_13 99 / 145
Reset to factory
settings - I&M data are
retained
The Reset to factory settings - I&M data retained functions resets the
module to its factory settings but retains the I&M data saved in memory.
Proceed as follows:
Click Connect online in the TIA portal.
After connection, mark the module in question.
Open the IMPACT67module in project navigation.
Double-click Online & Diagnostics.
Under the Functions tab, click Reset to factory settings to open a
window.
Activate the Retain I&M data selection.
Press the Reset button.
The module is reset to its factory settings.
Reset to factory
settings - default values
Tab. 8-43: Reset to factory settings - default values
Reset to factory
settings - I&M values
Tab. 8-44: Reset to factory settings - I&M values
Setting Value
IP address 0.0.0.0
Subnet mask 0.0.0.0
Router address 0.0.0.0
PROFINET device name Empty
I&M values Value
System ID code Empty
Place identifier Empty
Installed date Empty
Description Empty
Additional information Empty