EN
W415-1794 / 06.28.18
45
finishing
Tear the embers into pieces and place along the front row of ports covering all of the burner area in front of the
small logs. Care should be taken to shred the embers into thin, small irregular pieces as only the exposed edges
of the fibre hairs will glow. The ember material will only glow when exposed to direct flame; however, care
should be taken to not block the burner ports.
Blocked burner ports can cause an incorrect flame pattern, carbon deposits and delayed ignition. PHAZER
TM
logs
glow when exposed to direct flame. Use only certified "glowing embers" and PHAZER
TM
logs available from your
authorized dealer / distributor.
10.7 glowing embers
Randomly place the charcoal embers along the front and sides of the log support in a realistic manner.
Fine dust found in the bottom of the bag should not be used.
• Do not block or close off the burner ports. Blocked ports can cause an incorrect fl ame pattern, carbon
deposits and delayed ignition.
• When supplied, charcoal embers, charcoal lumps and vermiculite are not to be placed on the burner.
note:
Charcoal embers are not to be placed on the burner.
10.8 charcoal embers
To Next Page
Loading...
Need help?
General
